Dismantling of the Control Board
1) Loosen 10 screws "E" at the back pancle as shown in gure 6
Dismantling of the Power Board
1) Loosen 5 screws "D" at the top of the Power Board as
shown in gure 7
D
Figure 7
3 - 2
E
Figure 6
Dismantling of the DVD Module
1) Loosen 4 screws "F" to remove the DVD Module as shown
in gure 8.
F
Figure 8
SERVICE POSITIONS
Service position A
Note:In some service positions the components or copper patterns of one board may risk touching its neighbouring pc boards or
metallic parts. To prevent such short-circuit use a piece of hard paper or other insulating material between them.
Service position B
3 - 2