Verifying That Mpls Te Over Bdi Is Operational; Troubleshooting Tips - Cisco ASR 920 Series Configuration

MPLS Traffic Engineering over Bridge Domain Interfaces
Command or Action
Step 5
end
Example:
Router(config-if)#

Verifying That MPLS TE over BDI Is Operational

To verify that MPLS TE over BDI can function, perform the following task.
SUMMARY STEPS
1. enable
2. show mpls traffic-eng tunnels brief
3. show mpls traffic-eng tunnels summary
4. show mpls traffic-eng tunnels tunnel1
DETAILED STEPS
Step 1 enable
Enables privileged EXEC mode.
Step 2 show mpls traffic-eng tunnels brief
Use this command to monitor and verify the state of the tunnels.
Step 3
show mpls traffic-eng tunnels summary
Use this command to monitor and verify the state of the tunnels.
Step 4
show mpls traffic-eng tunnels tunnel1
Use this command to verify that tunnels are up and using BDI.

Troubleshooting Tips

This section describes how you can use the
Router# show mpls traffic-eng tunnels tunnel5
Name: router_t5
Status:
Config Parameters:
end
Admin: up Oper: up
path option 1, type dynamic (Basis for Setup, path weight 2)
MPLS Traffic Engineering Path Calculation and Setup Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR
Verifying That MPLS TE over BDI Is Operational
Purpose
(Optional) Returns to privileged EXEC mode.
show mpls traffic-eng tunnels tunnel5
(Tunnel5) Destination: 3.3.3.3
Path: valid Signalling: connected
to check for issues.
920 Series)
47