Mpls Traffic Engineering Over Bridge Domain Interfaces; Prerequisites For Configuring Mpls Te Over Bdi - Cisco ASR 920 Series Configuration

MPLS Traffic Engineering over Bridge Domain
Interfaces
The MPLS Traffic Engineering(TE) over Bridge Domain Interfaces(BDI) feature enables MPLS traffic
engineering over Bridge Domain Interfaces.
•
•
•
•
•

Prerequisites for Configuring MPLS TE over BDI

You must have:
• Enabled MPLS TE on all relevant routers and interfaces
• Configured MPLS TE tunnels
Your network must support the following Cisco IOS features:
• IP Cisco Express Forwarding
• Multiprotocol Label Switching (MPLS)
Your network must support at least one of the following protocols:
• Intermediate SystemtoIntermediate System (ISIS)
• Open Shortest Path First (OSPF)
Prerequisites for Configuring MPLS TE over BDI, page 43
Restrictions for MPLS TE over BDI, page 44
Information About MPLS Traffic Engineering over BDI , page 44
How to Configure MPLS Traffic Engineering over BDI, page 44
Configuration Example for MPLS Traffic Engineering over BDI, page 48
MPLS Traffic Engineering Path Calculation and Setup Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR
3
C H A P T E R
920 Series)
43