1b Reorient magnet and board (if necessary).
a. Remove screws, wiring
cover and end blocks.
End Block
End Block
(with screw holes)
Spacer
1c
Place template and mark holes.
a. Place template on top corner, opposite of hinges.
b. Mark holes and prepare them per template.
4
Board
Magnet
c. Rotate magnet, end
blocks and wiring cover as
shown, then reassemble.
Wiring Cover
OR
LHR
RHR
Front Side
of Lock
b. Remove board.
Magnet
Front Side
of Lock
End Block
(with screw holes)
Spacer
Wiring Cover
End Block
d. Rotate board 180°,
then reassemble.
OR
Double