Changing The Signal Type; Adding Or Removing Channels - RCA VR651HF User Manual

Using On-Screen Menus
CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
3 Signal Type:
4 VCR Plus+ Setup
5 Cable Box Setup
6 SAT Setup
0 Exit
ADD/REMOVE CHANNELS
Channel 115
is presently ADDED
Press CLEAR to remove
Press MENU to exit
18

Changing the Signal Type

This feature is useful if your cable signal goes out; it allows you to switch to a
regular antenna for alternate television reception.
1. Press the MENU button to display the VCR MAIN MENU.
2. Press the 4 button to choose CHANNELS.
3. Press 3 to choose between Signal Type: Cable and Antenna. When
finished, press 0 to exit back to the Main Menu and 0 again to exit to
normal viewing.
CABLE

Adding or Removing Channels

You might want to add or remove channels after using Auto Channel Search,
especially if there are weak signals or channels with content you don't care for.
1. Press the MENU button to display the VCR MAIN MENU.
2. Press 4 to choose CHANNELS.
3. Press 2 to choose ADD/REMOVE CHANNELS. To go to the channel you
want to add or remove, use the remote control's CHANNEL + or – buttons
or enter a specific channel number using the number buttons.
Once the desired channel is displayed, the on-screen menu will tell you if
the channel is currently in the VCR's viewing list. Press the CLEAR button to
remove a channel from the available channels list or press the INFO button
to add it.
4. Press the MENU button to exit out of the menus.
Note: To view active channels, use the remote control's CHANNEL + and -
buttons. You can also access channels not available in the active channel
list by using the remote control's number buttons to enter the specific
channel number.
Chapter 2