Table of Contents
Advertisement
Introduction
Commercial Scan
Description: The purpose of Commercial Scan is to assist you in searching forward on a tape
through a block of commercials.
Requirements: A Commercial Scan is performed in 30-second units. Each press of the remote
control's SEARCH button adds an additional 30-seconds, up to a maximum of 5 minutes (10
total presses of the SEARCH button). If you press the SEARCH button and the timer is within
the 4:30-5:00 range, then the timer will be set to 5:00.
ShowSaver™ Memory Protection
Description: Set timer programs are stored indefinitely using the VCR's permanent memory.
This way, you'll never have to worry about losing your programs due to an extended power
outage.
Requirements: Store a daily or weekly timer program in the VCR's memory.
VCR
2
Pro-Tect Plus™ Locking
TIMER
Description: Locks the VCR so that buttons on the front panel and remote
control won't operate the VCR. This feature protects timer programs from
frustrating accidents such as being left on at the time of recording.
HI-FI
Requirements: Lock the VCR by pressing and holding the POWER button on
the remote control for six seconds until SAFE appears on the front panel display.
Unlock the VCR by pressing and holding the POWER button on the remote
control, again for six seconds. SAFE disappears from the front panel display
when the lock on the system has been released.
Front Audio/Video Input Jacks
Description: The VCR has Audio/Video (A/V) input jacks on both the front and
rear of the unit (there are output jacks on the rear panel only). The front A/V
jacks make it easy to plug in an external A/V device, such as a camcorder.
Requirements: Make sure that all A/V connections are snug. To see a
connected device's image, turn the VCR to its Video Line Input by pressing the
remote control's INPUT button.
Hi-Fi Quality Sound
Description: When using the VCR's A/V jacks, you can feed stereo quality
sound from your VCR to your TV or stereo. Stereo quality sound allows for two
separate channels of sound (Left and Right) to be heard.
Requirements: Using A/V jacks and cables to connect the VCR to the TV or
stereo (see page 53 for an advanced connection setup diagram).
SQPB S-VHS Quasi Playback
Description: Your VCR will be able to play back tapes recorded in S-VHS or
S-VHS-ET mode (in VHS quality).
Requirements: Insert a tape recorded in S-VHS or S-VHS-ET mode and press
the PLAY button on the remote control or PLAY•PAUSE on the VCR.
Advertisement
Table of Contents
