Table of Contents
Advertisement
Installation
IMPORTANT
Unplug all power to your existing LOOP products. Disconnect any LOOP
products from existing Manifold Hubs (including any Orbit LED lights, eFlux
Wave Pumps and eFlux DC Flow pumps.)
Note: Connection ports are labeled on back of the controller for reference.
When connecting LOOP products to controller, gently slide connector in and tighten.
Do not twist or rotate. Excessive force can damage pin connections.
1. Remove controller and all components from
box packaging.
2. Ensure all components are disconnected from
your existing LOOP system.
3. Connect Orbit LED lights to LED
Light #1(& LED Light #2) connectors.
4. If connecting audio USB speakers, insert
speaker plug into audio jack.
5. Connect eFlux Wave Pumps to Wave Pump
#1, (Wave Pump #2 & #3) connectors.
Before Installation:
LED Light #1
LED Light #2
Audio Speakers
Wave Pump #1
Wave Pump #2
Wave Pump #3
(or accessory pump)
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the LOOP 1690 and is the answer not in the manual?
Questions and answers