Oven Racks - GE TWIN FLEX PT9200 Owner's Manual

Electric self-cleaning convection
Hide thumbs Also See for TWIN FLEX PT9200:
Table of Contents

Advertisement

Available languages

Available languages

Oven Racks

Extension Racks
The racks that were provided with your oven (dark
enameled racks, not shiny) may remain in the oven
during the self-cleaning cycle without being damaged.
To manually clean racks, use warm, soapy water. Make
sure not to wash the rack slides on an extension rack.
put some vegetable oil on a soft cloth or paper towel and
an extension rack slide.
Periodically, after several self-clean cycles, the extension
rack slides may need to be lubricated using the graphite
lubricant shipped with your wall oven. To order additional
graphite lubricant read the Assistance and Accessories
sections at the beginning of this manual.
1. Remove extension rack from the oven. See the
Extension Oven Racks section.
2. Fully extend the rack on a table or countertop.
easy clean up.
using a paper towel. NOTE: Any graphite lubricant
wiped away must be replaced.
4. Shake the graphite lubricant before opening it.
Starting with left slide mechanism of the rack, place
four (4) small drops of lubricant on the two (2) bottom
tracks of the slide close to the bearing carriers.
5. Repeat for the right slide mechanism of the rack.
6. Open and close the rack several times to distribute
the lubricant.
7. Replace the cap on the lubricant and shake it again.
Turn the rack over and repeat steps 3, 4, 5 and 6.
8. Close the rack, turn rack right-side-up and place in
the oven. See the Extension Oven Racks section.
9. Repeat above steps for each rack.
NOTE:
lubricant sprays.
Flat and Offset Racks
Racks may be cleaned by hand with an abrasive
cleaner or steel wool. After cleaning, rinse the racks
with clean water and dry with a clean cloth. Gray
porcelain-coated oven racks may remain in the oven
during the self-cleaning cycle without being damaged.
with a light coating of vegetable oil after cleaning them
by hand or in the oven. This will help maintain the ease
of sliding the racks in and out of the oven.
49-80786-1
Flat Rack
Handles
handles in the upper oven.
Offset Rack
handles in the lower oven.
19

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents