Editing Programs - NJD Electronics IQ-MX80 User Manual

User Guide
steps which is 25 seconds long. If the program needs to be
shorter, touch the
To change colours and gobos, select the new combination,
deselect then reselect the lantern by pressing the lantern select
pad twice; or, to change the colour and gobo of all selected
lanterns, touch the
Real time programs can be built up one lantern at a time, or
in groups, until all 16 channels are involved, by repeating the
programming process,
programming, the lanterns that are not selected, will display the
patterns that have already been written, allowing movement of
lanterns to be synchronized.
The write enable/disable switch on the rear panel must be in
the enable position.
Select the program to be edited using the
the step to be edited using the step pad. Set the colours and
gobos and select the lanterns to be edited. Move the beams to
the required position using the joystick and touch
Extending programs.
Select the program to be edited using the PROG pad.
Using the STEP pad, select the step after the last step in the
existing program. Continue programming as above until the last
step of the new program is reached, and touch step to advance
to the next step, then select Lantern #1 and touch
Programs must be extended one step at a time, it is not possible
to extend programs using the real-time programming technique.
Shortening programs.
Select the program to be edited using the
the step pad, select the step which is one more than the last step
of the edited program and touch
The DMX system is a high-speed digital data system, which
can transmit all the information required for light dimmers, multi-
motor lighting effects etc. down a single cable.
Each unit connected to the DMX signal is given an address,
and it compares this to the data being sent on the DMX cable, so
© N.J.D. Electronics 1997
pad.
END
pad.
RUN
selecting

Editing programs

END
Notes on DMX.
IQ-MX80
different lanterns.
pad. Select
PROG
ENTER
pad. Using
PROG
.
-Page 9-
When
.
END.