Table of Contents
Advertisement
User Guide
switch on the rear panel is in the "enable" position. A battery
inside the IQ-MX80 retains the user programs when the mains
power is disconnected, provided that the IQ-MX80 is used at least
once every 3 months.
Select the animation mode by touching the
Green =sound animated
No led lit = variable speed animation - the speed is set on the
speed control
Red = stop/single step operation.
The lanterns will remain static, and will advance one step
when the
pad is touched.
STEP
When the IQ-MX80 reaches the end of the program it starts
again at the beginning. To run through all programs sequentially,
select run mode by touching the
The IQ-MX80 will run through each program four times and then
change to the next.
To return to manual mode, touch the
MX80 will return to the lanterns and the colours that were
selected when manual mode was exited.
Short-cut:
To change programs quickly, touch the
touch the lantern select pad that corresponds to the number of
the program required before releasing the
programs 1 to 16 are available by this method.
Manual Override:
Whilst running programs, the lantern select and colour/gobo
pads can be used as in manual mode, to override the program.
The only difference is the scroll speed which is fixed. When the
lantern is de-selected it resumes running the program.
To
remove
and select the lanterns to be removed.
BLACKOUT
Writing programs.
Programs 11 to 20 can be written by the user.
The write enable/disable switch on the rear panel must be in
the enable position.
Select write by touching the
flash. Select the required program by touching the prog pad, until
© N.J.D. Electronics 1997
RUN
certain
lanterns
WRITE
IQ-MX80
SOUND
pad. The run led will light.
pad. The IQ-
MAN.
PROG
PROG
from
a
program,
pad, the write LED will
-Page 7-
pad.
pad
and
pad. Only
select
Advertisement
Table of Contents
