Technical Specification - NJD Electronics IQ-MX80 User Manual
Controls up to 16 njd intelligent lighting products independently, controls: predator mx and hx, chroma hx and chroma 50,
microbeam 100, iq250 mk.1, 2 & 3, iq500 mk.1 & 2, datamoon, spectre, raptor, quasar, and sb500 super blitzer, joystick for manual ope
Table of Contents
Advertisement
User Guide
Wrong cable specification.
• Joystick operates colour and gobos instead of beam
position
DIL switches on lantern set incorrectly (it is likely that switch
#2 is on when it should be off)
• Microbeam, Datamoon or IQ250 gobos cannot be
selected separately
It is not possible to select gobos separately on these products
•
Other
manufacturers'
correctly
The IQ-MX80 is only intended to operate NJD lanterns
*A fault in the cable may affect lanterns anywhere in the DMX
chain, not necessaraily those adjacent to the fault.
Technical specification.
Dimensions:
Power supply:
Power requirements:
Mains input:
Fuse:
Sound input:
Impedance:
DMX output:
Channels
The IQ-MX80 complies with the following standards:
EN60950 electrical safety
EN55103 electromagnetic compatibility
EN60297 fascia panel dimensions
RS-485 Digital transmission system
USITT DMX512 Lighting control protocol
© N.J.D. Electronics 1997
products
482 × 133 × 100 mm
230V AC 50Hz
9VA
IEC connector
F250mA 5 × 20mm HBC to IEC127.
(located inside mains input connector)
¼" mono jack
0.775V to 60V rms (0 to +40dBm)
15kW
3-pin female XLR
Data+ = pin 2
Data- = pin 3
Earth = pin 1
1-128
Standards:
IQ-MX80
do
not
operate
-Page 11-
Advertisement
Table of Contents
