Related Manuals for NJD Electronics NJ164
Summary of Contents for NJD Electronics NJ164
- Page 1 NJ164 LED IP DMX BAR Waterproof aluminium case Long Life LEDs Low power consumption Stand-alone operation or DMX control Page 1...
- Page 2 NJ938. The wires are colour-coded as follows: • Brown = Live (phase) • Blue = Neutral • Green/Yellow = Earth • The NJ164 must be earthed for safe and reliable operation. Page 2...
-
Page 3: Product Safety
Adjust the angle of the hanging bracket to obtain the best display of the light beams. If the luminaire it to be used DMX controlled or in Master-slave mode, connect the DMX output from the first luminaire to the DMX input of the second; connect the DMX output from the second luminaire to the DMX input of the third;... -
Page 4: Program
OPERATION There are 3 modes of operation: Automatic, Master- slave, Program selection, and DMX controlled. The NJ164 is controlled by the 3 push-button switches located below the LED display at one end. The push-buttons operate as follows: LEFT = MODE. A long press (>2 seconds) of the left push-button changes the mode, a short press (<1... - Page 5 AUTOMATIC mode: In automatic mode the NJ164 runs through all its programs. To select Automatic mode press the MODE button for >2 seconds and release, and repeat this until is shown in the display. At this point, the run time, speed and flash time can be set.
- Page 6 2.FL INCREASE or DECREASE buttons to select the colour. DMX mode: The NJ164 may be controlled from DMX in 6 different modes: 2-channel mode uses two channels to control the luminaire - the first channel selects the program, and the second channel selects the speed.
- Page 7 In 3-channel mode the luminaire is entirely illuminated in the same colour. The three channels select the colour as follows: first channel - sets the brightness of the red LEDs. second channel - sets the brightness of the green LEDs. third channel - sets the brightness of the blue LEDs.
- Page 8 segment, red, green and blue LEDs. The 11th, 12th and 13th channels control the fourth segment, red, green and blue LEDs. The fourteenth channel sets the flash rate. 26-channel mode operates similarly to 14-channel mode, except that the luminaire is divided into eight segments instead of four.
- Page 9 0—8 9—17 18—26 Yellow 27—35 Green 36—44 Cyan 45—53 Blue 54—62 Magenta 63—71 White 72—80 Program 02 81—89 Program 03 90—98 Program 04 99—107 Program 05 108—116 Program 06 117—125 Program 07 126—134 Program 08 135—143 Program 09 144—152 Program 10 153—161 Program 11 162—170...
- Page 10 DMX start address is shown. The DMX START ADDRESS is the DMX address of the first DMX control channel. The 2nd DMX channel is at the DMX start address + 1, the 3rd DMX channel is at the DMX start address +2, etc.
-
Page 11: Technical Specification
TECHNICAL SPECIFICATION Dimensions: 1085×120×130 mm Weight: 5.3 kg Power supply: 230 V ˜ Power consumption: 40 W Operating current: 0.17 A Light source: 320 off 10 mm LED Beam Angle: 30° IP rating IP65 Mains input Waterproof connector DMX input/output Waterproof connector DISPOSAL AND RECYCLING You must not dispose of this appliance with domestic... - Page 12 SERVICE WARRANTY NJD guarantees the product free from defects in materials and workmanship for a period of one year. Should this luminaire be operated under conditions other than those recommended, at voltages other than the voltage indicated on the luminaire, or any attempts made to service or modify the luminaire, then the warranty will be rendered void.