Part Numbers - Cisco CPS-MSP-1RU-K9 User Manual

Part Numbers

Attach coaxial cables from the video cameras to the appropriate port on the BNC breakout panel.
Step 4
Figure E-10
Note •
•
Tip Keep a record of the channel used for each camera. Use this record when configuring the cameras in
the Cisco VSM software.
If the analog camera also includes PTZ controls, connect the camera serial cable to the Multiservices
Step 5
Platform Series serial port, as described in the
section on page
Configure the cameras, channels and features as described in the "Managing Analog Cameras" and
Step 6
"Managing Camera Feeds" sections in
Part Numbers
Table E-3
Seriess that support the cards, and accessories that are used to connect video cameras to the card.
Table E-3
PID
CPS-MSP-1RU-K9
CPS-MSP-2RU-K9
CIVS-ENC-8P
CIVS-ENC-16P
Cisco Physical Security Multiservices Platform Series User Guide
E-12
Front of BNC Breakout Panel: BNC Connectors
1 2 3 4 5 6 7
17 18 19 20 21 22 23
The video encoder channels are determined by the installed location of the card, not by the numbers
on the BNC panel. See the
information. For example, if three video capture cards are installed in a 2-RU server, the bottom card
can be attached to the top connector of a second BNC panel. The channel numbers for this bottom
video are 33 to 48, even though the BNC panel shows ports 1 to 16.
If the camera or coaxial cable is installed on the building exterior, the coaxial cable shield must be
connected to earth (grounded) at the entrance to the building. The shield connection should be done
in accordance with applicable national electrical installation codes. In the United States, this shield
connection is required by Section 820.93 of the National Electrical Code, ANSI/NFPA 70.
E-14.
lists the part numbers for 16 x D1 and 8 x D1 video capture cards, the Multiservices Platform
Part Numbers
Item
1-RU Multiservices
Platform Series
2-RU Multiservices
Platform Series
8 channel encoder
16 channel encoder
8 9 10
24 25 26
"Understanding Video Channel Numbers" section on page E-6
"Connecting and Configuring Analog PTZ Cameras"
Cisco Video Surveillance Manager User
Description
Supports a single 8 or 16 channel video capture
card.
Supports up to three 8 or 16 channel video capture
cards.
8 x D1 video capture card.
16 x D1 video capture card.
Appendix E 16 x D1 and 8 x D1 Video Capture Cards
11 12 13 14 15 16
27 28 29 30 31 32
Guide.
for more
OL-21838-03