Table of Contents
Advertisement
Chapter 1
Connections & Setup
Complete Auto Channel Search
The Auto Channel Search allows the TV/VCR to search for all channels viewable
through your antenna or cable TV system. This is sometimes called "auto
programming."
1. Press MENU on the remote to display the TV/VCR MAIN MENU.
2. Press 5 to display the SETUP menu.
3. Press 1 to start Auto Channel Search.
Allow the TV/VCR to search for all channels. Pressing any buttons during
the Auto Channel Search will stop the search and only some channels will
be in the TV/VCR's memory. When the search is complete the TV/VCR will
automatically tune to the first channel in the channel memory list.
Adding or Removing Channels
You might want to add or remove channels if some of them are not active, have
weak signals, or you do not want them in your channel memory. A channel that
has been removed can still be selected by pressing the remote control's number
buttons.
1. Press MENU on the remote to display the TV/VCR MAIN MENU.
2. Press 5 to display the SETUP menu.
3. Press 2 to display the ADD/REMOVE CHANNELS screen. Follow the on-
screen directions to add or remove a channel.
4. You can add or remove more channels by entering the channel number or
pressing CHAN up or down.
Setting the Signal Type (optional)
The TV/VCR automatically selects the signal type (cable or antenna) for you
during the Auto Channel Search. If you want to change the signal type, follow
the directions below.
1. Press MENU on the remote to display the TV/VCR MAIN MENU.
2. Press 5 to display the SETUP menu.
3. Press 5 to choose between the ANTENNA and CABLE.
After changing the signal type, you might need to re-enter the channel
number you are trying to receive. You might also need to run the Auto
Channel Search again.
11
Advertisement
Table of Contents
