Table of Contents
Advertisement
Setting Up the TV/VCR
Startup
7. Set the Signal Type.
Video
Time Set
Timer Record
Setup
VCR Setup
Closed Caption
8. Program the channels into memory (Auto Program).
Video
Time Set
Timer Record
Setup
VCR Setup
Closed Caption
4
The first step in programming your TV/VCR is to select the signal source.
A. Press MENU on the remote to display the main menu. Then press CH
until Setup is highlighted. Press VOL+ or - to display the Setup menu.
B. From the Setup menu, using the VOL- or VOL+ buttons, select Antenna if
your TV/VCR is connected to an antenna, or, depending on what type of
cable you have, select Cable STD, Cable HRC or Cable IRC. If you are not
sure what type of cable system you have, contact your cable company.
:Enter
:Move
:Exit
In order to automatically program channels into the TV/VCR's memory, you
must have already selected the signal source (see step 6), and the antenna or
cable system must be connected to the TV/VCR.
A. Press MENU on the remote to display the main menu. Then press the CH
4
or
button until Setup is highlighted. Press VOL+ to display the Setup menu.
B. From the Setup menu, press CH
C. Press the VOL+ or - button to begin programming channels into memory. The
TV/VCR places available channels in its memory. This may take a couple
minutes. Press MENU if you want to interrupt this process and return to
normal viewing. When the process is complete, press CH
newly programmed channels.
:Enter
:Move
:Exit
Setup
Air/Cable
Antenna
Auto Program
Add/Erase
Added
Sleep
Off
Language
English
:Adjust
:Move
:Menu
3
until Auto Program is highlighted.
Setup
Air/Cable
Antenna
Auto Program
Add/Erase
Added
Sleep
Off
Language
English
:Adjust
:Move
:Menu
3
4
or
Setup
Air/Cable
Cable IRC
Auto Program
Add/Erase
Added
Sleep
Off
Language
English
:Adjust
:Move
:Menu
3
3
4
or
to scan your
Auto Program
ANT
16
Advertisement
Table of Contents
