Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hans Grohe Talis 32040XX1
Summary of Contents for Hans Grohe Talis 32040XX1
- Page 1 Installation Instructions / Warranty Talis 32040XX1 32240XX1...
-
Page 2: Technical Data
Talis Lavatory Faucet 32040XX1 Talis Bidet Faucet 32240XX1 32040XX1 Technical Data Maximum flow rate Operating pressure: Recommended operating pressure: 14.5 - 72 psi Test pressure: Hot water temperature: Recommended hot water temp.: Hole size in mounting surface Max. mounting surface depth: 3/8”... -
Page 3: Installation
Installation Flush the hot and cold supplies thoroughly before installing the faucet! Place the faucet and sealing washer on the mount- ing surface. If the mounting surface is less than 3/16” thick, trim the sealing washer so that it is even with the bottom of the mounting surface. -
Page 4: Install The Pop-Up Drain
Use 3/8” compression fittings (not included) to con- nect the supply hoses to the hot and cold stops. Use two wrenches, as shown in the diagram, to prevent hose twisting. For proper operation of the faucet, the hot supply should be on the left, and the cold supply should be on the right. - Page 5 Attach the swivel connector to the end of the horizontal rod. Attach the swivel connector to the end of the pull rod. Position as desired and tighten with a small, flathead screwdriver. Re-set the High Temperature Limit Stop (optional) Close the drain or cover it with a wash cloth. Use a 4 mm Allen wrench to push the screw cover into the handle.
-
Page 6: Replacement Parts
User Instructions Pivot the handle up to turn the water on, down to turn the water off. Pivot the handle to the left for warmer water, to the right for colder water. Replacement Parts handle 1.1 screw cover flange cartridge cpl. seal aerator cpl. -
Page 7: Limited Lifetime Consumer Warranty
If you purchased the product for use primarily for any other purpose, including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Hansgrohe and Commercial products, and (ii) for 5 years, with respect to AXOR products. - Page 8 THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: Conditions, malfunctions or damage not resulting from defects in material or workmanship. Conditions, malfunctions or damage resulting from (1) normal wear and tear, improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no-rinse”...