Globalstar Sat-Fi Quick Start Manual page 5

WI-FI ANTENNA CONNECTION
Perform the following for the Wi-Fi Antenna connection:
1. Place the rubber O-Ring over the Wi-Fi antenna port.
2. Connect the Wi-Fi antenna to the Wi-Fi port on the back of the Sat-Fi unit - Finger tighten only.
WI-FI ANTENNA
RUBBER O-RING
POWERING ON SAT-FI
Sat-Fi automatically powers on when it is connected to a power source (see above illustration.)
1. Connect the appropriate power cable to the 12VDC power port on the back of the Sat-Fi unit
2. Connect the power cable to the appropriate power source (i.e. electrical outlet, cigarette lighter,
DC power source)
The LED on the front panel provides a visual indication of the Sat-Fi's status:
• ON (Solid Blue) – Sat-Fi is registered with the Globalstar Satellite Network and is able to send/receive
calls and data
• Fast Blinking – Sat-Fi is searching for service and/or registering with the Globalstar Satellite Network
• Slow Blinking – Sat-Fi is in use, either sending/receiving a call or data transmission
• OFF – Sat-Fi is not connected to a power source
LED Status
Indicator/Reset Button
SAT-FI POWER CABLE