Laserdisc Player; Programming The Universal Remote To Control A Laserdisc Player - RCA RV3693 User Manual

Programming the Remote
Programming the Universal Remote to
Control a Laserdisc Player
You may be able to program your remote to control a
laserdisc player. Use the codes shown to the right or on the
sheet packed with your remote.
Follow these steps to program your universal remote to
control your laserdisc player:
1. Turn on the laserdisc player.
2. Look up the brand and its code number(s) in the
code list.
3. Press and hold the VCR2•LD button on the remote.
4. Enter the three-digit code from the code list.
5. Release the VCR2•LD button, then press POWER to
see if the laserdisc player responds to the remote
commands. If it doesn't, try pressing VCR2•LD, then
POWER again.
6. Repeat steps 3 through 5 using the next code listed
for your brand until the laserdisc player responds
to the remote commands.
Laserdisc Player Codes
Pioneer ................................. 033, 037
ProScan ................................ 033, 037
RCA ....................................... 033, 037
This remote may not operate all
models of the brands shown.
34