Advertisement
This key is used to turn the receiver on and off (stand by).
These keys are used to change the channels.
These keys are used to increase and decrease the volume
level manually.
This is to receive the IR commands from the
RCU. Do not block the view of the sensor.
This SEGMENT display will show the current
channel number.While the receiver is in stand by mode, the display will show
the current time.
To watch scrambled
channels you should insert a smart card into Smart Card Interface issued the
service provider whom you subscribes to. Therefore you can watch only a
specific range of channels with entitlements in smart card. The smart card
includes information to decipher parameters necessary for descrambling the
program. Please note that the gold chip on the smart card should face
download and inward when you insert when you insert it into Smart Card
Interface.
: This port is to connect the coaxial cable from LNB of your Dish. The IF input is provided through
this port and the input frequency range is 950�2150MHz. Also the voltage switching 13V and 18V is
passed through this port.
: To enable the connection of an analog receiver. The receiver is provided with this port. Connect
this port to LNB IN port of the other receiver via RF Cable.
: This is used to connect your receiver with computer through a serial cable.
This port can be used for upgrading software.
: This port is for the connection to the extenal Hifi system which has a optical
S/PDIF input interface.
): These RCA connectors are used to connect any external
video and audio.
: This is used to connect your local RF channels to your TV through Loop.
: This is used to connect your TV through RF cable.
: This is to plug in the AC main power cord.
The input AC volts range is 95V~240V, 50/60Hz supply.
: This is used to connect your TV through S-Video Cable.
: The switch select RF 3,4 channel number.
: This is swith to turn on and off the AC main power.
⑤
①
⑨ ⑨
②
③
④
⑧
⑥
⑩
⑦
Advertisement
