About “Automatic Saving” Function; Operation Of “Automatic Saving” Function; If “Unused Hours”; If “Used Hours” - Panasonic NC-HU301P Service Manual

NC-HU301P, NC-HU401P
3.7. About "Automatic saving" function
• This unit remembers the daily use pattern, the hours this unit is used or not, after the power is supplied at first.
Refer to P.18 for the storage of the use pattern, the hours this unit is used or not.
This is a function to save electric power costs automatically "by stopping the power supply while this unit is not used" and
"starts boiling and keep warm at the preset temperature while used hours" based on stored pattern if Timer pad is pressed 5
times.
3.7.1. Operation of "Automatic saving" function
If "Timer" pad is pressed 5 times, following will be performed.
"Automatic" is displayed on LCD, and performs either mode of "Unused hours" or "Used hours".
3.7.1.1. If "Unused hours"
Stops power supply.
(Temperature starts to fall and keeps warm at this temperature.)
Display
"Keep warm" LED : OFF.
"Stand-by" is displayed in LCD.
Automatically switches based on stored use pattern.
3.7.1.2. If "Used hours"
Starts to boil, and keeps warm at set temperature.
Display
"Keep warm" LED : ON.
"Stand-by" is erased in LCD.
3.7.2. Features of this function
Point 1
Boiling will be started automatically at the "time for use" based on stored pattern while this function is activated.
Accordingly, if the power cord is connected to the socket branched from a same breaker connected to other equipment, and
the power is connected at the same time, the breaker may be tripped.
Point 2
Air pump method is available while this function is activated.
In this case, "Automatic" in LCD will be erased.
Point 3
Change of the keep warm temperature or timer can be set up even while this function is activated. If keep warm temperature
is set from "80" to "90", or "90" to "98", it is boiled until the temperature reaches to set temperature.
Boiling will be started at the time set by the timer function.
Point 4
While this function is activated, power will be cut off at the start of "Unused hours", and the temperature falls
accordingly. This is not a failure of unit.
Please check the signs "Automatic" and "Stand-by" in LCD when the water temperature falls as the result of this function.
(Long Boil/Reboiling LED : OFF)
[Automatic Stand-by]
(Long Boil/Reboiling LED : OFF)
[Automatic Stand-by]
— 17 —