Hall Effect Sensor - LG WM2688H*M Training Manual

WM2688H*M
WM2688H*M

HALL EFFECT SENSOR

The Hall Effect sensor is easily
removed and replaced. You'll have to
remove the rotor and stator to access
the sensor. When replacing the rotor,
you'll probably need a helper to hold
the drum in place when you push the
rotor onto the shaft. Otherwise, the
drum may move forward enough to
make replacing the bolt difficult. The
helper can also hold the drum from
turning while you tighten the bolt.
Before going to this trouble, check the
connector on the main board. It is the
red connector closest to the heat sink.
Pull the connector off and verify the
board is receiving a signal from the
sensor.
Page 23 of 64
Steam Washer
TRAINING MANUAL