Connections - LG WM2688H*M Training Manual

WM2688H*M Steam Washer

CONNECTIONS

WATER
Be sure the rubber washer is inside the hose end. Attach the hoses to the
washer (red is HOT, blue is COLD). Tighten them firmly but don't strip the plastic
threads on the washer connections.
DRAIN
The drain pipe should be firmly attached to the standpipe or the laundry tub or
sink where it drains. The pump has sufficient power to cause the pipe to move
around when the water is expelled. The pump can lift the drain water a maximum
of 96 inches (2.4 m), but there is no minimum height requirement. The vacuum
breaker in the drain line will prevent drainage by gravity or siphoning. The hose
can lay flat into a floor drain as long as the end of it is not submerged.
ELECTRICAL
The steam washer requires a 120 VAC, 60 Hz., dedicated, 20-amp circuit.
WM2688H*M Page 16 of 64 TRAINING MANUAL