Turbo Steam Generator (Tsg) - LG WM2688H*M Training Manual

WM2688H*M
DISASSEMBLY/REPAIR
The TSG (Turbo Steam Generator) is supplied as an assembly only; parts like
the sensor, thermistor, or heater cannot be replaced individually. Diagnosis is
limited to determining malfunction and replacing as an assembly. The steam
generator does not have to be removed from the machine to be drained. Be sure
to let the water cool to avoid a burn. Have a hose available to slip onto the
connector or a large towel to catch the water so it doesn't run down into the
machine cabinet. If you remove the steam generator before draining it, be sure to
avoid tipping it and spilling the water.
WM2688H*M
(Turbo Steam Generator)
1. The steam generator can be
removed as an assembly for
diagnosis and replacement.
2. Unplug the washer.
3. Disconnect all electrical
connections, including ground.
4. Drain the water. (You can drain
the water later and it is easier.)
5. Remove all the cable straps by
squeezing the tabs and pulling
them out. They can be reused.
6. Remove the four screws
holding the support rail in
place and two screws attaching
the steam generator.
7. Disconnect the hoses (water
input and steam output.)
8. Push the steam generator
toward the back of the washer
to release it from the side rail.
You can then remove it for
draining, inspection, and
replacement.
It is sold as an assembly and
is not repairable.
Page 51 of 64
Steam Washer
TRAINING MANUAL