Table of Contents
Advertisement
Section 2: Installation
INSTALLING THE CHANGER
1. Remove power from vendor.
2. Remove the acceptor from the changer by
releasing acceptor latches and pulling the top of
the acceptor forward, away from changer.
Unplug ribbon cable from changer. Free lower
acceptor studs from changer housing. With the
acceptor removed, set key holes in back of
changer housing over mounting screw in the
vendor. Tighten snugly.
3. Set desired changer options (See Option Switch
Setting).
4. Replace the acceptor by inserting bottom
acceptor studs into changer housing guides. Plug
the acceptor ribbon cable into the changer. Press
top of acceptor into changer housing until top
acceptor studs lock into changer's acceptor
latches.
5. Plug changer into 6-pin vendor socket.
6. Load coin tubes making sure all coins lie flat.
7. Apply power to vendor.
8. Test changer with a variety of coins to ensure
proper operation.
NOTE: SAVE THE COIN CHANGER CARTON.
Always store coin changer in its shipping carton
when not in use. This will keep the unit clean and
protected.
OPTION SWITCH SETTING
See Figure 2.0
1. Hinge acceptor down by releasing acceptor
latches and pulling the top of the acceptor
forward, away from changer.
2. Located in the upper portion of the changer,
behind the acceptor, is a single switch module
containing three rocker switches. When the top
of the rocker switch is pushed in it is the ON
position. The switches correspond as follows:
1=USA/CAN Not Used
2=LO 25¢
ON: Quarters are directed to cash
box once change tube has
approximately 28 quarters
OFF: Quarters are put into change
tube until it is full.
3=$ACPT
ON: Dollar coin will be accepted
OFF: Dollar coin will be rejected
3. Set option switches to desired setting.
4. Return acceptor to operating position making
sure acceptor latches secure acceptor.
5. Test with a variety of coins to ensure proper
operation.
Figure 2
Page 5
Hide quick links:
Advertisement
Table of Contents
