Disassembling Payout Base; Clearing Coin Jams - Coinco CoinPro 3 Operation And Service Manual

Section 4: Maintenance
Figure 11
Page 12

DISASSEMBLING PAYOUT BASE

FOR CLEANING
Remove the four Phillips head screws from the
bottom plate. Remove bottom plate and individual
slides. Clean parts with mild detergent and hot water
as desired. DO NOT SUBMERGE
SOLENOIDS IN WATER.
Replace slides making sure part numbers face up
into changer. With the slides correctly seated on
plunger tabs, reinstall the bottom plate, securing with
bottom screws. Reinstall payout module into
changer, securing with side screws.

CLEARING COIN JAMS

Should a coin jam occur in the cash box chute area,
use the following steps to help dislodge coins:
1. Remove changer from vendor.
2. Keeping changer in an upright position, insert a
narrow screwdriver into cash box chute or reject
chute from bottom of changer to relieve jam.
Access holes are also provided at the rear of the
changer housing to help relieve coin jam.
CAUTION: Excessive screwdriver pressure or
twisting can cause permanent damage to the coin
changer.