Unpacking And Installation; Location; Electrical Requirements - Thermo Scientific MaxQ 5000 Operating Manual And Parts List

Unpacking and Installation

Section 4
This should be inspected upon delivery. When received, carefully examine
for any shipping damage before unpacking. If damage is discovered, the
delivering carrier should specify and sign for the damage on your copy of
the delivery receipt.
Open the carton carefully making certain that all parts are accounted for
before packaging materials are discarded. After unpacking, if damage is
found, promptly report it to the carrier and request a damage inspection
properly.
Important Failure to request an inspection of damage within a few days
after receipt of shipment absolves the carrier from any liability for damage.
Call for a damage inspection promptly.

Location

Put the shaker on a level surface capable of supporting the weight of the
shaker with any accessories while in operation.
Place shaker near an electrical outlet that matches the unit's nameplate
requirements.
Allow approximately 12" (30.5 cm) of clearance around the unit for free
air convection and user convenience.
Shakers with refrigeration should be placed near an accessible drain. Route
the drainage tube on the back of the unit to this drain.
Electrical
Models SHKA5000, SHKA5000-7, SHKE5000 and SHKE5000-7 shakers
require a 120 VAC, 50/60 Hz power source. They are supplied with a 3-
Requirements
wire line cord and should be plugged into an outlet designed for 3-prong
plugs. If an extension cord is used, it also should be the 3-wire grounded
type. For an outlet designed to accept 2-prong plugs (ungrounded), it is
required that a qualified electrician replaces the outlet with a new,
grounded type.
Refrigerated models require a dedicated power source. SHKA5000-7 and
SHKE5000-7 are supplied with a 20 amp power cord.
Thermo Scientific MaxQ 5000 Shaker 4-1