Troubleshooting Guide - Memorex MET1297 Instruction Manual

Symptom Possible Problem
The USB power adaptor
(not included) is not
plugged into a wall outlet
or the USB cable
(included) is not plugged
No
into the micro USB jack
Charging
on the MW546
Wall outlet is not
functioning.
Computer USB port is
not functioning.
Speaker batteries are
dead
Bluetooth speaker is
not linked with the cell
phone
No Sound
Speaker placement
out of range
Volume set too low
Volume level is set too
high.
Sound is
distorted.
Sound source is
distorted.
Unit gets
warm after
extended This is normal.
play at high
volume.
8

TROUBLESHOOTING GUIDE

Plug the USB power adaptor (not
included) into a wall outlet and plug the
USB cable (included) into the micro USB
jack on the MW546
Plug another device into the same
outlet to confirm the outlet is working.
Make sure your computer power is
turned on and try another USB port.
Recharge the speaker batteries
Go through pairing section
process to link the speakers.
Relocate the speaker within
Bluetooth operating range
Press the Volume+ button to turn the
sound level up.
Decrease the volume.
If the cell-phone original sound
source is of poor quality, distortion
and noise are easily noticed with
high-power speakers. Try a different
audio source such as a music CD.
If you are using an external sound
source like older generation of iPod,
try reducing the output volume on the
device itself. Also try turning bass
boost OFF or change the EQ setting.
Turn the unit off for a period of time
or lower volume.
Solution