Allocation Of Displays To The Bm50 - Lennox CLIMATIC 50 User Manual

ALLOCATION OF DISPLAYS TO THE BM50

Function
Ensure there is a good connection between the BM50 and its displays
Description
For each Climatic™50 card the following setting must be made using the DS50.
Disconnect the pLan bus at J10 and J11 and connect the DS50, directly to J10 of the BM50;
Sds.1
Sds.5
Sds.6 (for the DC50)
Trm1 is reserved to allocate the DC50 to the BM50.
Its value differs depending on the pLan address of the BM50
(See the opposite table)
Its status is always 'Pr'
Trm3 is reserved to allocate the DS50 to the BM50.
Its value is always 32
Its status is always 'Sh'
If the terminal remains inactive (no button is pressed) for 30 seconds, the configuration procedure is aborted automatically.
CLIMATIC™50 – Chiller / Heat Pump – Customer version
CL50-CHILLER-IOM_CUST-0808-E
Access the configuration
for at least 5 seconds until the Sds.1 screen appears:

 to position the cursor over the 'Setting' line
Press the button

 again to position the cursor over the 'I/O board adress' line
Press button
 
or   r eplace '- -' with the address of the BM50 connected
With button
and confirmed with button
The Sds.5 screen appears.

Press button
The Sds.6 screen appears.
The field "P:XX " shows the selected pLan address. In this example the value
"01" has been selected.
The fields in the "Adr" column represent the addresses of the terminal
displays associated with this BM50, while the "Priv/Shared" column indicates
the status of the selected terminal.
Pr: Private
Sh: Shared
Sp: Shared Printer (N/A)
Move the cursor from field to field using button
Select the value desired using button
To exit the configuration procedure and save the data, select the "OK?No",
field, choose "Yes" using buttons
mode by pressing


 
or  .
 
or
  a nd confirm by pressing
pLan address
of the BM50
1
2
3
4

,
buttons

Trm1
DC50
17 pr
18 pr
19 pr
20 pr
Page 16