THOMSON SpeedTouchTM706 User Manual page 53

Using the services on
the phone
E-DOC-CTC-20051017-0148 v1.0
The following table explains how to use a telephony service. The commands
depend on your provider's configuration and might be different from those
described here. For more information, see your provider's documentation.
Make sure your phone is off-hook when you dial the commands.
If your phone does not have an
the hook for 1/2 second and then dial the command number.
To use the service:
Call Hold
Call Waiting
Call Transfer
R or another hook flash button, put down
Proceed as follows:
To put person A on hold:
1
Dial R, 2 to put the call with person A on hold.
2
Dial R, 1 to retrieve the call on hold.
To put person A on hold and set up a call to person
B:
1
Dial R, 2 to put the call with person A on hold.
2
Wait for the dialling tone, and dial the number
of person B.
3
Dial R, 2 to switch back to person A.
Person B is put on hold.
You are in a phone conversation with person A
while person B is calling you. The phone produces
a waiting tone and - if CLIP is enabled and CLIR
disabled - displays the number of person B.
Do one of the following:
To reject the incoming call, dial R, 0.
To terminate the first call and to switch to the
waiting call, dial R, 1.
If you do not want to terminate the first call,
dial R, 2 to keep the first caller on hold while
answering the second call.
To return to person A while putting
person B on hold, dial R, 2.
To return to person A while terminating
the call with person B, dial R, 1.
You receive a phone call from person A and you
want to transfer him to person B.
1
Dial R, 2.
2
Wait for the dialling tone.
3
Dial the number of person B.
Person B picks up the phone.
4
Dial R, 4 to transfer the call.
5
Hang up.
Chapter 4
Voice over IP
45