Table of Contents
Advertisement
Removing full-width server
Prerequisite
Ensure that you read the Safety instructions.
About this task
Enter the context of your task here (optional). This is where introductory content goes.
Steps
1
Press the release latches on the side of the server.
2
Slide the server out of the block.
Figure 52. Removing full-width server
Installing full-width server
1
Align the server with the bay, and insert the server into the block.
2
Slide the server in until it is fully seated in the block.
The server locks in place after it is properly seated.
Installation and Service Manual
Installing and removing system components
79
Advertisement
Table of Contents
