Cisco Catalyst 2960 series Configuration Manual page 44

Configuring VTP on a Per-Port Basis
SUMMARY STEPS
1. configure terminal
2. interface interface-id
3. vtp
4. end
5. show running-config interface interface-id
6. show vtp status
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
Switch# configure terminal
Step 2 interface interface-id
Example:
Switch(config)# interface gigabitethernet1/0/1
Step 3
vtp
Example:
Switch(config)# vtp
Step 4 end
Example:
Switch(config)# end
Step 5 show running-config interface interface-id
Example:
Switch# show running-config interface
gigabitethernet1/0/1
Step 6
show vtp status
Example:
Switch# show vtp status
Catalyst 2960-X Switch VLAN Configuration Guide, Cisco IOS Release 15.0(2)EX
32
Purpose
Enters the global configuration mode.
Identifies an interface, and enters interface
configuration mode.
Enables VTP on the specified port.
Returns to privileged EXEC mode.
Verifies the change to the port.
Verifies the configuration.
Configuring VTP
OL-29065