Kenwood DMX6018BT Instruction Manual page 34

Settings Settings
Determining the value for <Position/DTA>
adjustment
If you specify the distance from the center of the
currently set listening position to every speaker, the
delay time will be automatically computed and set.
1 Determine the center of the currently set
listening position as the reference point.
2 Measure the distances from the reference point
to the speakers.
3 Calculate the differences between the distance of
the furthest speaker and other speakers.
4 Set the DTA value calculated in step 3 for
individual speakers.
5 Adjust gain for individual speakers.
E.g. When [Front All] is selected as the listening
position
60 cm
80 cm
150 cm
+0 cm
30 ENGLISH
<Fader/Balance>
Touch [ J ]/[ K
<Fader>
Adjusts the front and rear speaker output balance.
When using a two-speaker system, set the fader to the
center (0).
• F15 to R15 (Initial: 0)
<Balance>
Adjusts the left and right speaker output balance.
• L15 to R15 (Initial: 0)
To clear the adjustment: Touch [Center].
<Volume Offset>
Adjust and store the auto-adjustment volume level
for each source. The volume level will automatically
increase or decrease when you change the source.
If you have increased the volume first, then reduced
+90 cm
the volume using the Volume Offset, the sound
generated if you suddenly switch to another source
may be extremely loud.
• –5 to +5 (Initial: 0)
To initialize the setting value: Touch [Initialise].
+70 cm
<Sound Effect>
Adjust the sound effect.
<Bass Boost>
Selects the bass boost level.
• OFF (Initial)/1/2/3
]/[ H ]/[ I ] or drag the mark to adjust.
<Loudness>
Adjusts loudness. (The LOUD indicator lights up when
the loudness is adjusted.)
• OFF (Initial)/Low/High
<Drive Equalizer>
Reduces the driving noise by raising the bandwidth.
• OFF (Initial)/ON
<Space Enhancer>*
Virtually enhances the sound space using the Digital
Signal Processor (DSP) system. Select the enhance
level.
• OFF (Initial)/Small/Medium/Large
<Supreme>
Restores the sound lost due to audio compression to a
realistic sound.
• OFF/ON (Initial)
<Realizer>
Virtually makes the sound more realistic using the
Digital Signal Processor (DSP) system. Select the sound
level.
• OFF (Initial)/1/2/3
<Stage EQ>
Moves the localization of the sound image to the
lower or higher point. Select the height.
• OFF (Initial)/Low/Middle/High
* You cannot change the setting when "Radio" is selected as the
source.