Vehicle Info - Bosch MD-200 User Manual

When available, this selection will automatically take
the user to the special test screen where the test
group menu will be displayed. Make a selection to
enter the test, then follow the on-screen prompts.
Mode 8 will not be supported on all vehicles. If you
wish to run an EVAP test on a vehicle that does not
support Mode 8, enter vehicle specific mode and
refer to the Special Tests section on how to run a
special test.
Special Tests Button Definitions
Menu Button
Tapping the Menu button displays a
pop-up link that takes the user to more
buttons.
View Help
Selecting View Help will open an online
user manual.
Use Metric Units
Selecting Metric Units will switch from
English/Standard Units to Metric Units.
Use English/Standard Units
Selecting English/Standard Units will
switch from Metric Units to English/
Standard Units.
Take Screen Capture
Selecting Take Screen Capture will save a
copy of the current open screen.

Vehicle Info

Mode 9 views Vehicle Identification Numbers (VINs),
calibration ID(s), and verification number(s).
ss02729
Generic OBDII
READINESS MODE 1 Vehicle Information (Mode 9)
DATA STREAM MODE 1
Make sure the key is ON and the Engine is OFF.
FREEZE FRAME MODE 2
OK
DTCs MODES 3, 4, 7, A
O2 SENSORS MODE 5
NON-CONTINUOUS TESTS
MODE 6
SPECIAL TESTS MODE 8
VEHICLE INFO MODE 9
1. Select Vehicle Info from the Generic OBDII screen.
2. Follow the prompts on the screen.
©Mitchell International, Inc.
Menu
Cancel
User Manual | Mitchell Diagnostics | Scan Tool | 23 | en
ss02730
Generic OBDII
READINESS MODE 1 Vehicle Information (Mode 9)
DATA STREAM MODE 1
Vehicle identification Number
FREEZE FRAME MODE 2
Controller
DTCs MODES 3, 4, 7, A
ENGINE
O2 SENSORS MODE 5
Calibration identification Number
NON-CONTINUOUS TESTS
Controller
MODE 6
SPECIAL TESTS MODE 8
ENGINE
VEHICLE INFO MODE 9
The 17 digit VIN provides information on the vehicle
including year of manufacture, engine and possibly
transmission type, vehicle body style, and color.
Mode 9 is not supported on older vehicles, so a visual
check of the VIN through the windshield or on the
door sticker would be required to obtain that VIN.
Mode 9 is used on the tool to AutoID the vehicle
and for calibration verification to see if a newer
calibration is available for re-flashing the ECU.
Vehicle Info Button Definitions
Menu Button
Tapping the Menu button displays a
pop-up link that takes the user to more
buttons.
View Help
Selecting View Help will open an online
user manual.
Use Metric Units
Selecting Metric Units will switch from
English/Standard Units to Metric Units.
Use English/Standard Units
Selecting English/Standard Units will
switch from Metric Units to English/Stan-
dard Units.
Take Screen Capture
Selecting Take Screen Capture will save a
copy of the current open screen.
581624 | REV. B | 06.2017 | APDMD032018
Menu
Vehicle Identification Number
1FTPW14V28FC54321
Calibration Identification Number
BOSCHA1037366956