Oxygen (O2) Sensors - Bosch MD-200 User Manual

DTCs Modes 3, 4, 5, A Button Definitions
Clear DTCs Button
The Clear DTCs button is used to clear
codes and remove all but permanent
DTCs on the selected controller. To clear
codes, complete the following:
NOTE:
• Clearing DTCs will erase current
Mode 1 Readiness monitor
information and require the user go
through necessary drive cycles over
again. So, if Mode 1 information
needs to be reviewed, be sure to view
it before clearing codes.
• If a code will not clear, turn the
ignition off for at least 10 seconds;
turn it back on to KOEO, then retry.
Some controllers will go to sleep after
a period of inactivity and prevent
clearing DTCs. This key cycle may be
needed when attempting to
communicate with other controllers
after a period of time on a different
controller.
Refresh DTCs Button
Tapping the Refresh button initiates a
fresh scan of DTCs from the vehicle.
Share DTCs Button
Tapping the Share button opens the
app and initiates options. Depending on
what's available at the time. Share a list
containing all the DTCs set by email or
Bluetooth or USB.
Menu Button
Tapping the Menu button displays a pop-
up link that takes the user to help content
related to reading DTCs.
Note: An active internet connection will be
required.
Use Metric Units
Selecting Metric Units will switch from
English/Standard Units to Metric Units.
Use English/Standard Units
Selecting English/Standard Units will
switch from Metric Units to English/Stan-
dard Units.
Take Screen Capture
Selecting Take Screen Capture will save a
copy of the current open screen.
©Mitchell International, Inc.
User Manual | Mitchell Diagnostics | Scan Tool | 21 | en

Oxygen (O2) Sensors

Mode 5 views O2 sensor monitor test results.
ss02724
Generic OBDII
READINESS MODE 1 Oxygen Sensor Tests (Mode 5)
DATA STREAM MODE 1
Description
FREEZE FRAME MODE 2
Bank 1 Sensor 1
DTCs MODES 3, 4, 7, A
Maximum Sensor Voltage For Test Cycle
O2 SENSORS MODE 5
Lean To Rich Sensor Threshold Voltage
NON-CONTINUOUS TESTS
High Sensor Voltage For Switch Time
MODE 6
Calculation
SPECIAL TESTS MODE 8
Minimum Sensor Voltage For Test Cycle
VEHICLE INFO MODE 9
Mode 5 displays the average of the O2 sensor
monitor test results measured over a period of time.
The parameters of this measurement vary between
manufacturers. It may be necessary to run the
vehicle for a period of time to allow the O2 sensors
to fully warm up and begin operating as intended.
Oxygen (O2) Sensors Button Definitions
Menu Button
Tapping the Menu button displays a
pop-up link that takes the user to more
buttons.
View Help
Selecting View Help will open an online
user manual.
Use Metric Units
Selecting Metric Units will switch from
English/Standard Units to Metric Units.
Use English/Standard Units
Selecting English/Standard Units will
switch from Metric Units to English/Stan-
dard Units.
Take Screen Capture
Selecting Take Screen Capture will save a
copy of the current open screen.
581624 | REV. B | 06.2017 | APDMD032018
Share Menu
Min Value Max Units
0.000 0.003 1.275 V
0.000 0.003 1.275 V
0.000 0.003 1.275 V
0.000 0.003 1.275 V