Table of Contents
Advertisement
User Manual | Mitchell Diagnostics | Scan Tool | 22 | en
Non-Continuous Tests
Mode 6 views onboard monitoring test results for
noncontinuous monitor systems.
ss02725
Generic OBDII
READINESS MODE 1
Non-Continuously Monitored Tests
(Mode 6)
DATA STREAM MODE 1
Component parameters may not be valid if Readiness Status is
'Not Ready'.
FREEZE FRAME MODE 2
OK
DTCs MODES 3, 4, 7, A
O2 SENSORS MODE 5
NON-CONTINUOUS TESTS
MODE 6
SPECIAL TESTS MODE 8
VEHICLE INFO MODE 9
1. Select Non-Continuous Tests from the Generic
OBDII screen.
2. Follow the prompts on the screen.
ss02726
Generic OBDII
READINESS MODE 1
Non-Continuously Monitored Tests
(Mode 6)
DATA STREAM MODE 1
FREEZE FRAME MODE 2
ECU: ENGINE
DTCs MODES 3, 4, 7, A
TID 1
TID 1
CID 1
TID 1
O2 SENSORS MODE 5
N/A
NON-CONTINUOUS TESTS
MIN
MODE 6
TID 2
TID 2
SPECIAL TESTS MODE 8
CID 2
TID 2
VEHICLE INFO MODE 9
N/A
MIN
Non-Continuous Monitor Tests (Mode 6) are a pass/
fail test. Some examples are certain EVAP tests,
catalyst, and EGR. The following information is
reported:
• ECU.
• TID (test identification) which indicates the
system monitor.
• CID (component identification) which indicates
the component tested and its test value.
• Minimum value, maximum value, and current
value for each non-continuous monitor
supported.
• Pass or fail test results.
Each vehicle manufacturer assigns a code number
to their system monitors and components. Refer
to the vehicle manufacturers Mode 6 code chart
to determine the failure indicated by the TID and
CID. If this chart is not available, run an automated
system test (AST) from the DTC screen and select
Mode 6. See Read DTCs section for more information
regarding steps to complete that action.
©Mitchell International, Inc.
Share
Menu
Cancel
Share
Menu
Failed
31744
28832
N/A
VALUE
MAX
UNITS
Failed
31744
28832
N/A
VALUE
MAX
UNITS
Non-Continuous Tests Button Definitions
Menu Button
Tapping the Menu button displays a
pop-up link that takes the user to more
buttons.
View Help
Selecting View Help will open an online
user manual.
Use Metric Units
Selecting Metric Units will switch from
English/Standard Units to Metric Units.
Use English/Standard Units
Selecting English/Standard Units will
switch from Metric Units to English/Stan-
dard Units.
Take Screen Capture
Selecting Take Screen Capture will save a
copy of the current open screen.
Special Tests
Mode 8 controls the operation of an onboard
system, test, or component which is typically the
EVAP system or diesel particulate filter (DPF) test.
ss02727
Generic OBDII
READINESS MODE 1
DATA STREAM MODE 1
FREEZE FRAME MODE 2
DTCs MODES 3, 4, 7, A
TAP 'SPECIAL TESTS MODE 8' TO REOPEN
O2 SENSORS MODE 5
NON-CONTINUOUS TESTS
MODE 6
SPECIAL TESTS MODE 8
VEHICLE INFO MODE 9
1. Select Special Tests from the Generic OBDII screen.
ss02728
SPECIAL TESTS
ALL TESTS
All Special Tests
Search All Special Tests
DPF TESTS
DPF Tests
EVAP TESTS
Diesel Particulate Filter Regeneration
EVAP Tests
Evaporative System Leak Check
581624 | REV. B | 06.2017 | APDMD032018
Menu
Menu
Advertisement
Table of Contents
