Table of Contents
Advertisement
User Manual | Mitchell Diagnostics | Scan Tool | 42 | en
Key Programming
Displays instructions for the selected vehicle for
programming a key.
1. Select Key Programming from the Diagnostic
Information screen.
ss02807
Key Programming
2004 Ford F-150 XL 5.4L ABS (4WABS)
Battery Replacement
Battery Replacement
See Image
Immobilizer
Remote Alarm/Central
Locking
2. Follow the prompts on the screen to program a
key and or replace battery in key.
Battery Disconnect
Displays procedures for disconnect the battery on
the selected vehicle.
1. Select Battery Disconnect from the Diagnostic
Information screen.
ss02808
Battery Disconnect
2004 Ford F-150 XL 5.4L ABS (4WABS)
Battery Location
Battery Location
See image
General information
Before Battery
Disconnection
Before Battery
Connection
1 2 2 4 4 8
2. Follow the prompts on the screen to disconnect
and connect the battery.
3. Follow procedures for updating vehicle systems
after battery has been disconnected.
TMPS Quick Info
Describes the operating procedures for the Tire
Pressure Monitor System (TPMS) for the selected
©Mitchell International, Inc.
vehicle.
1. Select TMPS Quick Info from the Diagnostic
Information screen.
ss02809
TPMS Quick Information
2009 Honda Accord LX 2.4L TIRE PRESSURE MONITOR
Description
DESCRIPTION
Menu
RESET PROCEDURES...
System Description: When the vehicle speed exceeds 28 mph (45 km/h),
the Tire Pressure Monitor System (TPMS) Control Unit monitors the
pressure in all four tires and the system itself. System Operation: The
RESET TRIGGER
TPMS has two LED indicators that are part of the gauge module; a low-
pressure indicator and a system indicator. When the TPMS Control Unit
TORQUE SPECS
detects low pressure in a tire (or a problem in the system) it turns on the
appropriate indicator(s). If low tirw pressure is detected, the low pressure
TPMS SENSOR PART
indicator comes on. If a problem in the system is detected, the TPMS
NUMBER
indicator comes on. If low tire pressure and a problem in the system are
detected, only the TPMS indicator comes on. With the system functioning
properly, the low pressure indicator should come on when the ignition is
turned ON. It should then go off 2 seconds later. If this is not the case, there
Is a problem with the system. If the system detects low pressure in any tire,
2. Follow the prompts on the screen to reset the tire
pressure monitors.
Diagnostic Information Button Definitions
Change Controller Button
Tapping the Change Controller button
displays the select controller screen.
Menu Button
Tapping the Menu button displays a pop-
up link that takes the user to help content
related to reading DTCs.
Note: an active internet connection will be
required.
Menu
View Help
Selecting View Help will open an online
user manual.
Take Screen Capture
Selecting Take Screen Capture will save a
copy of the current open screen.
Automated System Test
Overview
The Automated System Test (AST) will scan all
available controllers on the selected vehicle for
Modes 1-7.
Depending on the vehicle, the handset may ask
qualifying questions concerning particular controller
581624 | REV. B | 06.2017 | APDMD032018
Menu
Advertisement
Table of Contents
