Yamaha BRX-610 Service Manual page 25

BRX-610/NS-PZ20
9. Press the " " (On/standby) key to turn on the power.
The FA mode is activated and the screen appears on the TV monitor as shown below. (Fig. 12)
TV monitor screen
Insert Disc : CD-ROM
Current Disc :
Current Stage :
Press "Stop" key to disable FA mode and UI exit OSD TEST mode
10. Load the test disc on the disc tray according to the direction displayed on the TV monitor screen, and push the disc tray
to close it. Then playback starts automatically, and then the disc tray opens automatically after playback ends. (Fig. 13)
Repeat above procedure 4 times to complete the playback capability test by using 4 kinds of test discs.
TV monitor screen
Insert Disc : BD-ROM SL
Current Disc : BD-R DL
Current Stage : Test fi nish
Press "Stop" key to disable FA mode and UI exit OSD TEST mode
11. "Pass" is displayed when the playback capability test is completed successfully.
If "Fail" is displayed, check that the test discs are not dirty and scratched, then perform test from procedure 8 again.
12. Press the " " (Stop) key to cancel the FA mode.
TV monitor screen is turned off and "OK C3" is displayed on the FL display of this unit.
13. Press the " " (On/Standby) key to turn off the power.
Note: Be sure to cancel the FA mode by pressing the " " (Stop) key before turning off the power. Otherwise the FA
mode is activated next time the power is turned on.
30
Pass
Fig. 12
* Required time for play
• BD-ROM SL :
• BD-R DL :
• DVD-ROM DL : About 60 seconds
• CD-ROM :
(BD ROM DL: Not for service)
Fig. 13
About 30 seconds
About 60 seconds
About 30 seconds