Non-Garmin Equipment; Garmin Software And Documents - Garmin G5 Installation Manual

1.6 Non-Garmin Equipment

1.6.1 Wiring/Cabling Considerations
The installer will provide all wiring and cabling unless otherwise noted.
1.6.2 Contact and Crimp Tools
Recommended crimp tools used to build the wiring harnesses for the G5 are listed in Table 1-2. Equivalent
crimp tools may also be used.
Table 1-2 Pin Contact and Crimp Tools Part Numbers
Garmin Contact
Contact Type
Socket, Size 20,
20-24 AWG
NOTE
Non-Garmin part numbers shown are not maintained by Garmin and consequently are subject
to change without notice.
1.6.3 BNC Connectors
BNC connectors may be required to terminate the GPS antenna cable, depending upon which antenna is
used. Check the GPS antenna installation instructions for detailed information.
1.6.4 Hex Driver
A 3/32" hex drive tool is required to secure the G5 to the panel as described in
1.6.5 SD Card
A microSD™ card can be used with the G5 for software updates and data logging. Garmin recommends
SanDisk® brand SD cards up to 32 GB.
1.6.6 Pneumatic Hoses and Connectors
Air hoses and fittings are required to connect pitot and static air to the G5. The G5 has a female 1/8-27
ANPT fitting for each pitot and static port. Use appropriate aircraft fittings to connect to pitot and static
system lines.
1.6.7 Silicone Fusion Tape
Use Garmin Part Number 249-00114-00 or similar to wrap the wiring/cable bundles.

1.7 Garmin Software and Documents

The G5 unit software and a panel cut-out DXF file are available for free download from
http://www8.garmin.com/support/collection.jsp?product=010-01485-00.
190-02072-01
Rev. 2
Recommended
Part Number Positioner
M22520/2-08,
336-00022-02
Daniels K13-1
Recommended Recommended
Insertion/ Hand Crimping
Extraction Tool
M81969/1-04 for
size 22D pins and M22520/2-01,
M81969/1-02 for Daniels AFM8
size 20 pins
Section 3, G5 Installation.
G5 Installation Manual
Tool
Page 1-4