Amped Wireless REB175P User Manual page 121

REB175P
menu and reconfigure your Source Network connection. You can also set a static channel number on
your router to prevent this from happening again in the future.
g. If you cannot access the setup menu, check to see that the Range Extender / Bridge is still on. Reboot
the Range Extender / Bridge by unplugging the power adapter and plugging it back in. Check to see if
your connection has been reestablished by viewing a website. If you do not have a connection, logon
to http://setup.ampedwireless.com
h. Check to see that the wireless router is still on. If it has been turned off please turn it back on. The
Range Extender should automatically reconnect to your Source Network within 10 minutes.
I have a dual-band router and I cannot extend the network (or both networks).
a. The Range Extender / Bridge will repeat or connect the 2.4GHz signal and the 5.0GHz signal from your
router simultaneously in Range Extender Mode and WDS-Bridge mode only. If you are using another
mode, the Range Extender / Bridge will only connect to a single network.
b. When connecting to dual band networks in Range Extender or WDS-Bridge mode, the networks must
have a signal strength of 70% or greater with the Range Extender / Bridge for a reliable connection.
Make sure that your dual band router is close enough to the Range Extender / Bridge to receive a strong
signal.
USER'S GUIDE
and configure a new Source Network connection.
120