Amped Wireless REB175P User Manual page 118

REB175P
(10) seconds then let go. After the Range Extender has fully reset, use an Ethernet cable and connect
to the Range Extender. Login to the Web Menu at
the Wizard.
Troubleshooting: Source Network Connection Issues
I cannot connect to my Source Network. I received an error when running Basic Setup.
a. Your Source Network may be secured. Double check that you have the correct security key to connect
to the Source Network.
b. Your Range Extender / Bridge may be located too far from your Source Network. Run through the Basic
Setup Wizard again. On the SCAN page, your Source Network should show a signal strength of 70% or
greater. If it does not, move the Range Extender / Bridge closer to your Source Network and try again.
c. If you are connecting to a dual band router, both networks (2.4GHz and 5.0GHz) should have a signal
strength of 70% or greater.
d. Check that your antennas are connected to their corresponding antenna connectors. The number
designated on the antenna (1-3) should match the number on the antenna connector (1-3).
e. Check to see that your Source Network router's DHCP server is enabled. The Range Extender / Bridge
needs to obtain an IP from your Source Network router.
USER'S GUIDE
http://setup.ampedwireless.com and run through
117