Jeep XJ Manual page 23

XJ
REMOVAL AND INSTALLATION (Continued)
REMOVAL
GLOVE BOX HINGE, BIN, INNER DOOR AND LATCH
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the glove box from the instrument
panel. Refer to Glove Box - Removal in the
Removal and Installation section of this group for the
procedures.
(3) Remove the seven screws that secure the inner
glove box door to the outer glove box door (Fig. 18).
Fig. 18 Glove Box Components Remove/Install
(4) Remove the inner glove box door unit from the
outer glove box door.
GLOVE BOX OUTER DOOR
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the glove box from the instrument
panel. Refer to Glove Box - Removal in the
Removal and Installation section of this group for the
procedures.
(3) Remove the seven screws that secure the inner
glove box door to the outer glove box door (Fig. 18).
(4) Remove the outer glove box door from the inner
glove box door unit.
GLOVE BOX LOCK CYLINDER
(1) Insert the key into the glove box lock cylinder
and turn the lock cylinder to the unlocked position.
(2) Open the glove box.
(3) With the key still in the lock cylinder, insert a
small pin punch or a stiff wire into the lock cylinder
release hole (Fig. 19) and depress the lock cylinder
retaining tumbler.
(4) While holding the retaining tumbler depressed,
rotate the key in the lock cylinder clockwise and
INSTRUMENT PANEL SYSTEMS
Fig. 19 Glove Box Lock Cylinder Remove/Install
press outward on the back of the lock cylinder from
the inside of the glove box door until the lock cylin-
der comes out of the glove box latch lock cylinder
bore.
INSTALLATION
GLOVE BOX HINGE, BIN, INNER DOOR AND LATCH
(1) Position the inner glove box door unit onto the
outer glove box door.
(2) Install and tighten the seven screws that
secure the inner glove box door to the outer glove box
door. Tighten the screws to 2.2 N·m (20 in. lbs.).
(3) Install the glove box onto the instrument panel.
Refer to Glove Box - Installation in the Removal
and Installation section of this group for the proce-
dures.
(4) Reconnect the battery negative cable.
GLOVE BOX OUTER DOOR
(1) Position the outer glove box door onto the inner
glove box door unit.
(2) Install and tighten the seven screws that
secure the inner glove box door to the outer glove box
door. Tighten the screws to 2.2 N·m (20 in. lbs.).
(3) Install the glove box onto the instrument panel.
Refer to Glove Box - Installation in the Removal
and Installation section of this group for the proce-
dures.
(4) Reconnect the battery negative cable.
GLOVE BOX LOCK CYLINDER
(1) To install the lock cylinder, insert the key into
the cylinder and align the lock cylinder tumblers
with the ramp in the glove box latch lock cylinder
bore. The ramp is located at about the 7 o'clock posi-
tion.
(2) Push the glove box lock cylinder firmly into the
lock cylinder bore while rotating the key and cylinder
counterclockwise to the 6 o'clock position, where the
lock cylinder retaining tumbler will snap back into
place.
8E - 23