Jeep XJ Manual page 19

XJ
REMOVAL AND INSTALLATION (Continued)
(3) Turn the bulb holder counterclockwise about
sixty degrees on the cluster electronic circuit board.
(4) Pull the bulb and bulb holder unit straight
back to remove it from the bulb mounting hole in the
cluster electronic circuit board (Fig. 13).
Fig. 13 Cluster Bulb Locations
CLUSTER LENS
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument cluster from the instru-
ment panel. Refer to Instrument Cluster in the
Removal and Installation section of this group for the
procedures.
(3) Work around the perimeter of the cluster hous-
ing to disengage each of the latches that secure the
cluster lens to the cluster housing (Fig. 14).
ter housing.
ODOMETER RESET KNOB BOOT
cable.
ment panel. Refer to Instrument Cluster in the
Removal and Installation section of this group for the
procedures.
ing. Refer to Instrument Cluster Components -
Cluster Lens in the Removal and Installation sec-
tion of this group for the procedures.
ing it out of the cluster lens.
CLUSTER HOOD AND MASK
cable.
ment panel. Refer to Instrument Cluster in the
Removal and Installation section of this group for the
procedures.
ing. Refer to Instrument Cluster Components -
Cluster Lens in the Removal and Installation sec-
tion of this group for the procedures.
Fig. 14 Instrument Cluster Components
INSTRUMENT PANEL SYSTEMS
(4) Gently pull the cluster lens away from the clus-
(1) Disconnect and isolate the battery negative
(2) Remove the instrument cluster from the instru-
(3) Remove the cluster lens from the cluster hous-
(4) Remove the odometer reset knob boot by pull-
(1) Disconnect and isolate the battery negative
(2) Remove the instrument cluster from the instru-
(3) Remove the cluster lens from the cluster hous-
8E - 19