Controls
>
Combination Switch
1 Low beam (with lighting switch
turned clockwise two notches)
2 High beam (with lighting switch
turned clockwise two notches)
3 High beam flasher (high beam
available independent of lighting
switch position)
4 Turn signals, right
5 Turn signals, left
22
To operate the turn signals, move
the combination switch past the
point of resistance (up or down).
The switch is automatically can
celled when the steering wheel is
turned by a large enough angle.
To signal minor directional changes
of the vehicle, such as changing
lanes on a highway, move combina
tion switch to the point of resis
tance only and hold it there.
6 Control for windshield washer
system
When the washer system is
switched on, the wipers also
operate.
7 Windshield wiper control
0 Windshield wiper switched off
1 Intermittent wiping
II Normal wiper speed
III High wiper speed
Note:
If one of the turn signals fails, the
turn signal indicator system flashes
and sounds at a faster sequence
than under normal operating condi
tions.