Main - THUNDER TIGER TTR4572 Assembly Manual

12. Secure control horn with furnished 2x14mm
screws and control horn backplate.
) X f / X h g
@ ) f V / X h g
@ H g N 1 h g @ e @ K @ f O ) X g
@ e @ @ @ @ @ @ @ @ @ @ @ , g
@ @ @ @ @ @ @ @ @ H e ) X e W . Y h @ W @ K C ( M g W ( Y g
@ @ f O & Y h g I @ J @ ) e . Y h
@ W . @ @ @ @ @ @ @ @ @ @ @ @ @ g
@ @ @ @ H f @ f @ h e @ ( Y e @ f @ h e
@ M @ e J 5 e J 5 h e
@ e J @ ) K e J 5 h f @ e 7 U e 7 H h e
@ e . M I 4 6 T & U h f @ g S @ @ ) K h e
@ f O . M I 4 6 X h
@ @ @ 5 e O & 0 Y g V / h @ e W 2 ( Y e I / X h
I ( Y @ @ 0 M
13. Trail fit main wing in place then place
fuselage bottom section and make marks on
the bottom wing.
14. Draw a parallel line offset about 5/32"(4mm).
Locate 4 pieces of bottom section mount and
place the mounts right on the lines as shown.
Z
9
W W I I N N G G A A S S S S E E M M B B L L Y Y
Locate the wing mounting plate and place it
at the center and away from trailing edge
about 1/8"(3mm). Make marks around these
wood parts.
15. Remove the covering of the marks you made.
16. Glue the wood parts in place with thick CA or
epoxy. Note that wing mounting plate is
1/8"(3mm) away from trailing edge.
AB
4mm
3mm