1. Decide the position of hinge then carefully cut
slots at trailing edge and aileron.
2. Insert hinges in place and use pin to position the
hinge in the center .
3. Attach the aileron to the trailing edge, remove
all pins then drop CA to the hinges at both sides.
Same procedure on the other aileron.
4. Locate the servo wire opening doubler, use fine
tip marker to mark where covering is going to
remove.
5. Remove the covering about 1/8"(3mm) inside
the line you drew. Be careful only cut the
covering or it will hurt the planking.
6. Glue the doubler in place with instant CA glue.
7
W W I I N N G G A A S S S S E E M M B B L L Y Y
3mm