Installation; Connecting The Microphone - Yaesu FT-891 Operating Manual

Hf/50 mhz transceiver

Hide thumbs Also See for FT-891:

Table of Contents

1. Insert the microphone's plug into the recessed jack on the transceiver, as shown in the

illustration.

Note: When disconnecting the microphone, pull the cable while pressing the connec-

tor latch.

2. You may position the microphone cable so as to cause it to exit from the side or the

bottom of the transceiver. Just route the cable into the appropriate channel provided,

as shown in the illustration.

3. Connect the Control cable between the Front Panel and Transceiver Body.

4. Install the Front Panel by sliding it into the position shown; you will hear a "click" when

the panel locks into place.

5. To remove the Front Panel, use your left thumb to push rearward (slightly) the latch

on the left-hand of the panel, then slide the Front Panel to the right and away from the

transceiver.

FT-891 Operating Manual

Application for FCC / IC

FCC ID: K6620651X50 / IC: 511B-20651X50

Installation

Table of Contents

Show Quick Links

Table of Contents