Tv + Dvd + Vcr - RCA R52WH73 User Manual

TV + DVD + VCr

1. Connect your DVD Player to your TV.
A. Connect the audio (white and red) cables to the CMP1 L and R audio input jacks on the back of the TV and to the
audio output jacks on the DVD player.
B. Connect three video grade cables to the CMP1 Y P
DVD player.
Notes:
If your DVD player does not have Y P
jack on the TV using an S-Video cable.
If your DVD player does not have an S-Video jack, connect the player to the VID1 V (Video) jack on the back of the TV
using a video cable.
Important: If you use the VID1 S-VIDEO or V (Video) jack to connect your TV to the DVD player, you must connect the
audio cables to the VID1 L/MONO and R jacks on the TV.
2. Connect your VCR to your TV.
A. Connect a coaxial cable to the VCR's antenna output jack and to the ANTENNA/CABLE ANALOG INPUT jack on the TV.
B. Connect the audio (white and red) cables to the VID2 L/MONO and R audio input jacks on the back of the TV and
to the audio output jacks on the VCR.
C. Connect the video cable to the VID2 V (Video) jack on the back of the TV and to the video output jack on the VCR.
3. Make sure cable or antenna is connected to your VCR.
Connect the coaxial cable from your cable outlet or antenna to the antenna input jack on the VCR.
4. Connect the coaxial cable from an off-air antenna to the ANTENNA DIGITAL INPUT jack.
Note: Do not connect a digital cable signal to this input.
Chapter 
P jacks on the back of the TV and to the Y P
b r
P jacks, but does have an S-Video jack, connect the player to the VID1 S-VIDEO
b r
Connections & Setup
P jacks on the
b r
• To review other
connections, go to the
next page.
• If you are done
connecting devices to
your TV, go to page 16 to
complete the Initial Setup.
• If you want more details
of the jacks on your TV, go
to page 18.