Other Information
Can't select certain channel
•
Make sure the remote control is in TV mode. Press the TV button and enter the channel number using the number buttons.
•
Channel may be blocked or not approved in the Parental Controls menu.
•
If using a VCR, check to make sure the TV/VCR button on the VCR is in the correct mode (press the TV/VCR button on your VCR).
noisy stereo reception
•
May be a weak station. Use Sound menu to choose mono sound.
no picture, no sound but TV is on
•
Maybe the Signal Source is set to the wrong choice. Go to page 48 for detailed instructions.
•
The channel might be blank — change channels.
•
If you're watching your VCR and it's connected with a coaxial cable, tune the TV to channel 3 or 4 (whichever channel is selected on
the 3/4 switch on the back of your VCR). Also check to make sure the TV/VCR button on the VCR is in the correct mode (press the
TV/VCR button on your VCR).
Volume buttons not adjusting volume louder
•
Check to make sure volume isn't limited by the maximum volume feature. Go to page 48 for more instructions.
Picture not moving
•
You have activated the Freeze feature by pressing FREEZE or OK on the remote. Press any button to "unfreeze" the picture.
Black box appears on the screen
•
Closed-captioning might be on. Check Closed Caption in the Setup menu. Go to page 49 for more instructions.
Freeze not working
•
The freeze feature is not available for Component video (CMP1 or CMP2) or DVI inputs.
Low battery warning appears on screen
•
Place new batteries in remote.
TV picture keeps switching between screen formats abruptly
•
Switch the Autoformat feature to Off. See page 44 for more information.
Channel search finds few channels
•
The cable connected to the ANTENNA/CABLE ANALOG INPUT and/or ANTENNA DIGITAL INPUT jack might be loose.
•
Your off-air antenna might be getting a weak signal. Move it higher or get a bigger antenna.
•
If you have cable TV, make sure that signal is connected to the ANTENNA/CABLE ANALOG INPUT—do not connect it to the
ANTENNA DIGITAL INPUT.
•
If you have a cable box, you can't connect it to the ANTENNA DIGITAL INPUT jack. Connect it to the ANTENNA/CABLE ANALOG
INPUT or a Video Input jack.
•
Select the Both option in the Channel Search menu, and retry the channel search.
The Remote Control Doesn't Work
•
Something might be between the remote and the remote sensor on the component. Make sure there is a clear path.
•
Maybe the remote isn't aimed directly at the device (TV or DVD) that you're trying to operate.
Continues on next page...
Chapter