Table of Contents
Advertisement
Co n nectio ns
Setup
VCR
TV (backpanel)
TV + DVD + VCR
* If you connect an S-Video cable, you must connect
the audio cables to the VIDEO I AUDIO jacks on the
back of the TV, not the VIDEO2 AUDIO jacks.
I.
Connect your DVD Player to your TV.
A. Connect the audio (white and red) cables to the VIDEO2 Rand L/MONOAUDIOjacks on the back
of the IV and to the Audio Output jacks on the DVDplayer.
B. If your DVD player has Component
Output Jacks (Y, Pb, Pr), connect three video grade cables to
the Y, Pb, Pr jacks on the DVD player and to the VIDEO 2 Y, Pb, Pr jacks on the back of the IV. If
your DVD player doesn't have Y, Pb, Pr jacks, go to C.
-OR-
C. If your DVD player has an S-Video jack, connect an S-Video cable to the S-Video jack on the DVD
player and to the S-VIDEO IN jack on the back of the IV. If your DVD player doesn't have an
S-Video jack, go to D.
Note: If you connect an S-Videocable,you must connect tile audio cables to the VIDEO1AUDiO jacks on tile beckof the
W, not the VIDEO 2 AUDIOjaoks.
-OR-
D, Connect a video cable (yellow] to the Video Output Jack on the DVD player and to the VIDEO 2
VIDEO jack on the back of the IV.
2. Connect your TV to your VCR
Connect a coaxial cable to the 1V ANT jack on your IV and to the Output Jackon your VCR
(sometimes labeled OUTTOIV).
Nore: If your VCR has A/V output jacks, you con connect your W to your VCRusing audio/video cables for better quolitg
3.
Make sure cable or antenna
is connected
to your VCR.
Connect the coaxial cable from your cable outlet or antenna to the antenna input on the VCR.
Go to page 7
4
Graphics contained
within this publication
are for representation
onlg
Chapter 1
Advertisement
Table of Contents
