Steamer Operation - Maxwell MW-3707 W Instruction Manual

ENGLISH
•
For children safety reasons do not leave poly-
ethylene bags used as packaging unattended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
•
Install and remove the brush attachment only
after the unit has cooled down completely.
•
Never pull the power cord when disconnecting
the unit from the mains, take the power plug
and carefully remove it from the mains socket.
•
Do not disassemble the unit by yourself, if any
malfunction is detected or after it was dropped,
apply to the nearest authorized service center.
•
Do not touch the surface of the unit marked
with the symbol
Danger of burns.
• Transport the unit in the original package only.
•
Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USAGE
ONLY
UNIT PURPOSE
The unit can be used for any types of clothes and
fabrics. If you have any doubts whether you can
use the unit to steam some fabric or clothes follow
manufacturer's recommendations.
If such information is not available, try to steam the
fabric from the backside.
When ironing such fabrics as silk or corduroy, treat
the fabric with steam by holding the sprayer (1)
away from the material.
Use the brush attachment (17) to remove unnec-
essary lint and threads.
BEFORE USING THE UNIT FOR THE FIRST TIME
• Unpack the unit, remove any stickers that can
prevent unit operation, place the unit on a flat
stable surface.
Note: After unit transportation or storage at
low temperature, it is necessary to keep the
unit for at least two hours at room tempera-
ture before using it.
• Set the telescopic stand (7) into the opening
on the unit body (11).
•
Fix the telescopic stand (7) by rotating the
clamp (8) clockwise (pic. 1).
•
Open the clamp (5) locks, extend the tele-
scopic stand (7) to the required length and
close the clamp (5) locks.
• Extend the hanger (4) and then install them on
the telescopic stand (7) (pic. 2).
MW-3707.indd 8
while ironing and after it.
•
Insert the steam hose (16) into the unit body
(11) outlet, matching the ledges on the clamp
(15) with the grooves of the outlet, and turn the
clamp clockwise (pic. 3).

STEAMER OPERATION

• To operate the steamer fill the tank (9) with
water. To remove the water tank take it and pull
upwards.
• Turn over the tank (9) and open the lid (10).
•
Fill the water tank (9) with water and screw the
lid (10) (pic. 4).
Attention!
Before removing the water tank (9) make sure
that the unit is unplugged. Do not use hot water.
To extend the operation period of the steamer
it is recommended to use distilled and demin-
eralised water. Do not switch the unit on if it is
empty.
•
Set the water tank (9) to its place.
•
Fix clean clothes on the hanger (4).
Note: Be careful when fixing clean clothes
on the hanger (4). Too strong pressure may
cause deformation.
Never steam clothes on a person as the steam
temperature is very high, use the hanger (4).
•
Connect the unit to the mains.
•
Use the switch (14) to select the required oper-
ation mode, the indicator (13) will light up.
Off The unit is switched off
Silk
Fiber
Linen
Cotton
•
Wait for intensive steam release from the
sprayer (1) openings. It will take some time
(45 seconds)
•
Hold the sprayer (1) by the handle (6); take
the sprayer (1) to the bottom of clothes item.
Steam will go along the external and internal
surface of fabric ironing the folds. Slowly move
the sprayer (1) vertically bottom-upwards.
Straighten the fabric using the free hand.
Note: Do not allow bending of the steam hose
(16).
• After finishing the operation of the unit set the
switch (14) to the "OFF" position and unplug
the unit.
• Let the clothes dry and cool down.
Notes: The continuous operation time of the
unit is no more than 45 minutes.
8
Silk
Synthetics
Linen
Cotton
29.12.2014 10:27:53